Universal Timer Module - M12
Xecro presents a new innovative concept to upgrade any sensor with unlimited timer options.
This compact universal timer module (UTM) can be easily spliced into a M12 connection cable and has countless useful features. The programable time intervals range from as little as a millisecond up to 49 days. The UTM has an autodetect PNP|NPN input as well as a PNP|NPN output, so that also type conversions are possible.
For common applications such as an Pulse-Stretching or PNP-to-NPN Conversion, the UTM can be delivered pre-programmed; individual programming is however possible via the USB-port of PCs running Windows.
All functions listed below are available in a small M12 housing:
General
- PNP|NPN auto-detect input
- software selectable PNP or NPN output
- unauthorized parameter change detection
Group 1
can be combined
- on-delay starting on an impulse only
- on-delay with permanent signal required
- off-delay, resettable
- off-delay, not resettable
Group 2
one of these at the same time
- over speed detector (NO|NC selectable)
- jam detector (NO|NC selectable)
- maximum frequency detector (NO|NC selectable)
- minimum frequency detector (NO|NC selectable)
Group 3
one of these at the same time
- blinking start with high phase when signal is present
- blinking start with low phase when signal is present
- blinking start with high phase when no signal is present
- blinking start with low phase when no signal is present
Group 4
can be combined
- negating the output NO -> NC / NC -> NO
- negating the polarity PNP -> NPN / NPN -> PNP
- flip-flop on rising signal
- flip-flop on falling signal
- impulse divider on rising signal
- impulse divider on falling signal
Group 4
can be combined
- negating the output NO -> NC / NC -> NO
- negating the polarity PNP -> NPN / NPN -> PNP
- flip-flop on rising signal
- flip-flop on falling signal
- impulse divider on rising signal
- impulse divider on falling signal
